Amica PI6514TFD EN Manual de usuario descargar pdf (Pagina 15)

OPERATION

Control Panel

● Immediately after the appliance is connected to electrical mains, all displays will light up

briey. Your induction hob is then ready for use.

● The induction hob is equipped with electronic touch control sensor elds, which are

operated by touching with a nger for at least 1 second.

● Touching of a sensor eld is accompanied by an acoustic signal to acknowledge.

No objects should be placed on the sensor elds (this could cause an error).

Touch sensor elds should be always kept clean.

Selecting the cooking zone heat setting

While the number "0" is ashing on the cooking zone display, you can start adjusting the heat

setting sliding your nger across the slider sensor (1). The default heat setting is "0".

Switching on the cooking zones

Once the appliance is switched on using the on/off touch sensor (5), select a cooking zone

(2) within the next 60 seconds.

1 When a cooking zone selection sensor eld (2) is touched, a ashing "0" will be displayed

on the corresponding heat setting indicator display. The display will ash for about 5 sec-

onds. Set a heat setting during this time.

Switching on the appliance

To switch on the appliance touch and hold the on/off sensor eld (5) for at least 1 second.

The appliance will sound an acoustic signal when it is ready for use. When the appliance

is ready for use, is shown on the timer display and symbols are shown on cooking

zone displays.

If none of the sensor elds is touched within 60 seconds, the appliance switches

itself off.

A cooking zone is active when a number is ashing on its display. This indicates

a cooking zone is ready for the heat setting to be set or changed.

Heat setting selection sensor (1) is a slider type touch control sensor allowing selec-

tion of heat setting (1-9) and timer setting (1-99) by touching and sliding your nger

across the marked area (1):

sliding right - increase the heat setting

sliding left - reduce the heat setting.

It is also possible to select the heat setting directly by touching the appropriate part of

the heat setting selection sensor eld (1).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Sin comentarios

Amica PI6514TFD EN Manual de usuario Pagina 15