Amica PB Manual de servicio descargar pdf (Pagina 10)

- 10 -

Please remember:

When switching the plate on and off or adjusting the heating power always touch only

one sensor (with the exception of switching off a hotplate or pot recognition func

tion). If you touch more than one sensor at the same time, the system will ignore the

entered settings and, should you keep touching the sensors for a long time, a fault

signal will be emitted.

Do not place any objects on the marked sensors (as a fault mode may be trigged) and

keep them clean all the time.

Switching on a hotplate

If the plate is not in operation, all the hotplates are switched off and the display is

blank. When you touch the main sensor (1), the plate switches on and all the hotplate

indicators (3) show “0” for about 10 seconds. You can now set the required heating

power by touching sensors “+”(5) or “-“ (4) (having selected a hotplate by touching

sensor (2) – see Setting up the heating power). Should you fail to activate any sensor

within 10 seconds, the plate will switch off automatically.

If the children lock is active, the hotplates cannot be switched on. After switching on

the plate with the main sensor (1), set the individual hotplates in the following man-

ner:

1. Select the desired hotplate with appropriate sensor (2).

The assignment of sensors to the respective hotplates corresponds with

the hotplates’ layout.

2. Set the required heating power by touching sensors +” (5) or „-”(4).

3. To change the set heating power, proceed as in point 1, so ﬁrst select the

desired hotplate with appropriate sensor (2) and then adjust the heating

power with „+” (5) or „-” (4) sensors.

Should you fail to activate any sensor within 10 seconds, the hotplate will switch off.

A hotplate is active when its indicator is lighted, which means that the hotplate is

ready to give up the set heat.

Double hotplate (if applicable)

To switch on the additional, outer hotplate you have to touch the double hotplate sensor

(6a,6b). A red LED diode (6a,6b) signals that the hotplate has been activated. To switch

off the additional, outer hotplate, touch the double hotplate sensor (6a,6b) again.

Advice: the additional, outer hotplate can only be activated when the inner hotplate

is active.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Sin comentarios

Amica PB Manual de servicio Pagina 10