Amica PG4ES11 Manual de instrucciones descargar pdf (Pagina 11)

INSTALLATION

Fix the mains connection cable in a stay wire.

Before connecting the plate to the electrical system read information provided on the rating

plate and wiring diagram.

NOTE! The installer is obliged to complete and leave with the user a “certicate of connect-

ing the plate to the mains” (attached to the warranty card). Methods of connection other than

those indicated on the diagram can damage the plate.

Connecting the plate to the electrical system

Note!

The plate can be connected to the mains only by a qualied certied installer. Wil-

ful adaptations or modications to the electrical system are prohibited.

Guidelines for the installer

The plate is factory-set for three-phase alternating current power supply (400 V 3N~50 Hz).

It may be adapted for one-phase current power supply (230 V) by adequate bridging on the

connection strip, in accordance with the attached wiring diagram. The wiring diagram is also

provided in the bottom part of the lower cover. The connection strip can be accessed once

the lid on the bottom cover is removed. Please remember to match the mains connection

cable to the type of connection and the rated power of the plate.

Note!

Do not forget to connect the protective circuit to a terminal of the connection strip

marked with sign. The plate power supply system should be protected by appro-

priately selected safety device or after the power supply protection, by appropriate

safety switch cutting off the power in case of emergency.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Sin comentarios

Amica PG4ES11 Manual de instrucciones Pagina 11